SuperC RV Group

Super C RVs => SuperC Info and Discussions => Topic started by: Ron Hall on June 13, 2008, 08:32:59 am

Title: Microware lowering project.
Post by: Ron Hall on June 13, 2008, 08:32:59 am
Yahoo Message Number: 1204 (http://groups.yahoo.com/neo/groups/supercrvgroup/conversations/messages/1204)
My wife is short. GS installed the Microwave so high that she needed a
stool to use it. We attended a FMCA rally Memorial Day weekend. Wife
took a Microwave/Convection oven class. This put the pressure on me to
make it so she can use microwave without the stool. Got it done. Turns
out it was not as bad a project as I thought. Lowering bottom panel of
microwave gave access to the 2 bolts that hold it to a back panel.
Loosened these 2 screws and Microwave was in my arms. Lowered the
panel that screws where using to hold up microwave. Modified area
above the new microwave location to make a cabinet. Bought a custom
made cabinet door off EBAY to match existing cabinets. While do the
project found that GS had installed vent fan to only send air out, but
not vent stove area. Installed a vent to outside. Life is good. Wife
is happy and so am I.
Title: Re: Microware lowering project.
Post by: Ron Hall on June 13, 2008, 08:56:42 am
Yahoo Message Number: 1206 (http://groups.yahoo.com/neo/groups/supercrvgroup/conversations/messages/1206)
See photos in my photo area here on Kodiak Chassis Class C Motorhomes.
http://autos.ph.groups.yahoo.com/group/KodiakChassisClassC/photos/browse/1c28 (http://autos.ph.groups.yahoo.com/group/KodiakChassisClassC/photos/browse/1c28)
Title: Re: Microware lowering project.
Post by: grandriver125 on June 13, 2008, 09:04:18 am
Yahoo Message Number: 1207 (http://groups.yahoo.com/neo/groups/supercrvgroup/conversations/messages/1207)
Ron, great photos and very helpful.

Airbags. Do tell us more. Make, cost, who installed, improvement, etc. Also look like something I'd like to add and I suspect what you did is much cheaper than the UltraRide I keep dreaming of (details of UR in files section). Maybe I should search the forum posts because you may have given us this info already. :)

Don


On 13-Jun-08, at 8:56 AM, Ron Hall wrote:

Title: Re: Microware lowering project.
Post by: Ron Hall on June 13, 2008, 09:11:17 am
Yahoo Message Number: 1209 (http://groups.yahoo.com/neo/groups/supercrvgroup/conversations/messages/1209)
Hey I can only type so fast. LOL You should have this info know.