Print Page - SCAN Guage question

Title: SCAN Guage question
Post by: Roger.swann on July 25, 2010, 09:45:57 pm

Yahoo Message Number: 4924 (http://groups.yahoo.com/neo/groups/supercrvgroup/conversations/messages/4924)

My Scan guage II was not working when I moved the MH today. I plugged it into the suburban and bingo it works. Any thoughts on why my OBD port is not powering the scan gauge II?

I have another code reader, but did not get a chance to see if it works on my OBD port.

I have an '06 chassis with the LLY duramax engine.

Roger

Title: Re: SCAN Guage question
Post by: Ron Hall on July 27, 2010, 02:14:08 am

Yahoo Message Number: 4930 (http://groups.yahoo.com/neo/groups/supercrvgroup/conversations/messages/4930)

My first guess would be a blown fuse. The obdII connection is powered by the same circuit that powers the cigarette lighter. Fuses are under lower panel on passenger side of dash. Requires a 10 mm wrench/socket to remove 2 screws.
Best
Ron Hall

Title: Re: SCAN Guage question
Post by: rsri1 on July 27, 2010, 09:50:28 am

Yahoo Message Number: 4932 (http://groups.yahoo.com/neo/groups/supercrvgroup/conversations/messages/4932)

I'll check the fuses, been in the panel before to wire the toad brake system. Let you all know.

SuperC RV Group

Super C RVs => SuperC Info and Discussions => Topic started by: Roger.swann on July 25, 2010, 09:45:57 pm