Finshed LED install.

April 02, 2011, 10:17:04 am

I finished my LED install. Purchased all my LED's off EBAY.
Put LED's in side running lights.
EBAY LED's.
Replaced all 10 clearance lights. Needed to re-caulk all these lights before I have leaks in the overhead. It was good time to replace.
More EBAY LED's
Replaced all 10 basement compartment lights with LED's. I have been know to leave them on and almost drain the batteries in a short time. The original 921 bulbs use 18 watts each. The T10 lights I put in use 2.5 watts each.
Even more EBAY LED's
Replace front directional signal lights. These required more work than just replacing the bulbs. Had to wire them in. I posted this change on Diesel Place. Here is a link to the thread.
LED replacement turn signal issue?
All the incandescent lights have been replace except for headlights, microwave and steps. Headlights will probably never get changed. Microwave needs AC bulbs. Have not looked into what it would take to replace them. The step bulb, I have not been able to figure out how to get lens off. When I do it will be changed.
Best
Ron Hall