Skip to main content ↑ ↓
Topic: (no subject) (Read 696 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

(no subject)

Yahoo Message Number: 16460
I can't locate the 175 amp fuse for the glow plugs in a chevy Kodak c5500

Anyo e know where it is?

Thanks

Joe

(No subject)

Reply #1 –
Yahoo Message Number: 16461
Fuses are in 2 places. Under hood passenger side on firewall.
Other place is passenger side of dash. Need to remove 2 screws with a 10 mm socket on bottom of dash. You see 2 groups of fuses and relays. On back side of panel that was removed is a schematic of their locations.
Best
Ron Hall

(No subject)

Reply #2 –
Yahoo Message Number: 16462
Fusible Link 1
In the engine chassis harness, from the fuse block - underhood (secondary) B+ bus to the glow plug control module (GPCM) fusible link 3
Power and Grounding Component Views
--

Fusible Link 2
In the engine chassis harness, from the fuse block - underhood (secondary) B+ bus to the Hydromax© relay
Power and Grounding Component Views
--

Fusible Link 3
In the engine chassis harness, from the engine chassis harness to the glow plug control module (GPCM) connector C1

You may be looking for a Fusible Link. Schematic shows #3.

Glow Plug Control Module (GPCM) (LLY)
Right front of the engine, mounted above the drive belt tensioner
Engine Controls Component Views
Engine Controls Connector End Views

Glow Plug Relay (LG4)
In the engine compartment on the right side of the fan shroud
Engine Controls Component Views
Engine Controls Connector End Views

Glow Plug Relay (LG5)
On the upper left side of the engine
Engine Controls Component Views
Engine Controls Connector End Views

Best
Ron Hall

Re:

Reply #3 –
Yahoo Message Number: 16463
Ron

Thanks for the info. Really appreciate it.

Do you have any thing further to help me identify the fuse able link

I agree it is likely the one going to the glow plug control module

Thanks

Joe

Re:

Reply #5 –
Yahoo Message Number: 16465
Thank

I will take a look

Have looked at the diagrams just having an issue identifying the link

Joe