Break control pre wire September 21, 2010, 01:35:58 pm Yahoo Message Number: 5493Hi folksDoes anyone know if our chassis comes pre wired for a break controlerI know it is pre wired on the hitch receiver with 7 and 4 pins plugs, but wonder if under the dash there is a harness with plug in connector for an electric break controler.Thank you all muchMoSent on the Now Network� from my Sprint® BlackBerry Quote Selected
Re: Break control pre wire Reply #1 – September 21, 2010, 01:55:54 pm Yahoo Message Number: 5494NO. It needs to be spliced into the wiring harness(es) in several places. I have attached theGM Upfitter / bodybuilder guide. Its fairly trivial but not plug and play as if it were not a Medium Duty Truck. Consumer grades have it all ready.....I hope this helps. Any good RV / Trailer / Towing shop can knock this out for $100 or less.VictorFrom: "agilityaussie@..." To: Kodiak Chassis group Sent: Tue, September 21, 2010 10:35:47 AMSubject: [KodiakChassisClassC] Break control pre wireHi folksDoes anyone know if our chassis comes pre wired for a break controlerI know it is pre wired on the hitch receiver with 7 and 4 pins plugs, but wonder if under the dash there is a harness with plug in connector for an electric break controler.Thank you all muchMoSent on the Now Network™ from my Sprint® BlackBerry Quote Selected
Re: Break control pre wire Reply #2 – September 21, 2010, 03:56:22 pm Yahoo Message Number: 5500Be sure to wire brake controller with connections shown in the bulletin. Do not wire to the brake switch. You should find the wire connection on passenger side frame rail. It will be located on inside of frame rail about where batteries are located in passenger step.BestRon Hall Quote Selected