2008 36MS July 25, 2013, 12:54:27 am Yahoo Message Number: 11595I ran into an issue with my main slide out, although I can get it to move I have to take the wall panel off the wall. I tried to recalibrate the unit and it starts to program correctly on the out mode but when i bring it in to calibrate and it gets into the right position the locks do not engage and i get both red and green flashing rapidly.I tried this a few times and no luck. The jayco tech support was not help either. I have it in the shop right now but I sure would be interested if anyone has had the same challenge i have.Tim Quote Selected
Re: 2008 36MS Reply #1 – July 25, 2013, 05:39:40 am Yahoo Message Number: 11598Control boardIf original for the year you will need an update versionThe original one looses the programmingOrder new one and swap, I had to do it and btw do it on the little slide as well it will happen on that on too.TksMo Quote Selected
Re: 2008 36MS Reply #2 – July 25, 2013, 08:56:33 am Yahoo Message Number: 11599I had the same problem. After replacing the control board several times I noticed that each time we forced a new board in place we were actually breaking the connections on the circuit board. I had the tech enlarge the hole so the board would go in without force. Everything worked perfectly after that.BillFrom: KodiakChassisClassC@yahoogroups.com [mailto:KodiakChassisClassC@yahoogroups.com] On Behalf Of agilityaussieSent: Thursday, July 25, 2013 2:40 AMTo: KodiakChassisClassC@yahoogroups.comSubject: Re: [KodiakChassisClassC] 2008 36MSControl boardIf original for the year you will need an update versionThe original one looses the programmingOrder new one and swap, I had to do it and btw do it on the little slide as well it will happen on that on too.TksMo Quote Selected